StarTech.com ECESAT32 Manuale utente
ExpressCard Serial ATA
Adapter Card
2-Port SATA 6Gbps ExpressCard
to eSATA Controller Card
ECESAT32
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver•
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company
in question. Regardless of any direct acknowledgement elsewhere in the body of
this document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
i
Table of Contents
Introduction..................................................................... 1
Packaging Contents.....................................................................1
System Requirements .................................................................1
Installation....................................................................... 2
Hardware Installation...................................................................2
Driver Installation.........................................................................2
ECESAT32 View ..........................................................................2
Verifying Installation.....................................................................3
Specifications.................................................................. 4
Technical Support........................................................... 5
Warranty Information...................................................... 5
1
Introduction
The StarTech.com 2-Port eSATA ExpressCard Controller Cards offers
simple connectivity between a laptop computer system and eSATA
revision 3.0 devices. A cost-effective solution for connecting high
RPM hard drives and Solid State Drives (SSD), which in turn allows
for easier data backups and archiving. With full support for SATA
revision 3.0 hard drives and data transfer speeds of up to 6 Gbps, as
well as backwards support for SATA revision 2.0 devices, the adapter
card features a native PCI Express single chip design that provides
enhanced compatibility, reliability and performance.
Packaging Contents
1 x ECESAT32 controller card•
1 x 34mm to 54mm Stabilizer Bracket•
1 x Driver Installation CD•
1 x Instruction Manual•
System Requirements
ExpressCard enabled computer system•
Microsoft• ®Windows®XP/Server 2003/Vista/Server 2008 R2/7
(32/64-bit), or Linux®
2
Installation
Hardware Installation
The ExpressCard adapter will simply slide into the ExpressCard slot
on any compatible system. Push the card all the way in, until it ‘clicks’
and locks into place. To eject the card, simply push the card further into
the slot until it clicks, and then release and it will then be automatically
ejected from the slot.
NOTE: Some ExpressCard/54 slots do not firmly hold an
ExpressCard/34 module, so the 34mm to 54mm stabilizer bracket may
be necessary.
Driver Installation
Windows XP/Server 2003/Vista/Server 2008 R2
After installing the card into the computer system, boot up the1.
computer.
Once logged into Windows, the Hardware/Driver installation wizard2.
should appear. Insert the Driver Installation CD into the CD/DVD
drive when prompted.
Windows should automatically start to search the CD for the3.
appropriate drivers. This may take several minutes.
eSATA
connector
ECESAT32 View
3
Once Windows has located the drivers and installed them, the card4.
should be ready for use.
Windows 7
No driver installation is required for Windows 7, as the controller card is
natively supported, so the drivers are already installed.
Verifying Installation
Windows XP/Server 2003/Vista/Server 2008 R2/7
From the main desktop, right-click on “My Computer” (“Computer”
in Vista or later), then select “Manage”. In the new Computer
Management window, select Device Manager from the left window
panel.
Under the “SCSI and RAID Controllers” category (“Storage Controllers”
in Vista or later), should be a “Marvell 91xx” device. Right-click on the
device and select “Properties” to make sure it is installed and working
correctly.
For Windows 7, if using the native drivers, the card will instead be listed
under the “IDE ATA/ATAPI Controller” category as a “Standard AHCI”
device.
4
Specications
Bus Interface ExpressCard 2.0
SATA revision 3.0
Connectors 2 x 7-pin eSATA
Chipset ID Marvell 9128
Maximum Data Transfer Rate SATA: 6Gbps
RAID Support 0, 1, JBOD (single)
Operating Temperature 5°C to 50°C (41°F to 122°F)
Storage Temperature -25°C to 70°C (-13°F to 158°F)
Humidity 15~90% RH
Compatible Operating
Systems
Windows XP/Server 2003/Vista/
Server 2008 R2/7 (32/64-bit),
Linux
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and
downloads.
Warranty Information
This product is backed by a lifetime warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server
Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Altri manuali per ECESAT32
1
Indice
Altri manuali StarTech.com Hardware per computer
StarTech.com
StarTech.com EC230USB Manuale utente
StarTech.com
StarTech.com PEX10000SFPI Manuale utente
StarTech.com
StarTech.com MPEX1394B3 Manuale utente
StarTech.com
StarTech.com SATSASBP425 Manuale utente
StarTech.com
StarTech.com ATXPOW430HS Manuale
StarTech.com
StarTech.com CMVBMOD Manuale utente
StarTech.com
StarTech.com SATSASBAY3BK Manuale utente
StarTech.com
StarTech.com 2P6GR-PCIE-SATA-CARD Manuale utente
StarTech.com
StarTech.com 2S232422485-PC-CARD Manuale utente
StarTech.com
StarTech.com PEXESATA2I Manuale utente
StarTech.com
StarTech.com PEXUSB311EI Manuale utente
StarTech.com
StarTech.com CBUSB220 Manuale utente
StarTech.com
StarTech.com SATABAY3 Manuale
StarTech.com
StarTech.com PEXUSB312A2 Manuale utente
StarTech.com
StarTech.com PEX4S953 Manuale utente
StarTech.com
StarTech.com PEX1S552LP Manuale
StarTech.com
StarTech.com CB1394B3 Manuale utente
StarTech.com
StarTech.com EC13941A1B Manuale utente
StarTech.com
StarTech.com ST10GPEXNDPI Manuale utente
StarTech.com
StarTech.com PEX1RISERF Manuale utente
Manuali Hardware per computer popolari di altre marche
EMC2
EMC2 VNX Series Manuale del proprietario
Panasonic
Panasonic DV0PM20105 Manuale utente
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuale utente
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuale utente
Raidon
Raidon iT2300 Manuale utente
National Instruments
National Instruments PXI-8186 Manuale utente
