Viso Systems BaseSpion Manuale utente
BaseSpion
Assembly manual
Last edited: Aug 2017
2
Package content and weight
The BaseSpion consist of 5 main assemblies as shown below.
Base – 14Kg 3 x sensor rail – 4Kg (12kg)
Sensor 4kg Tower 4kg
E27 Fixture – 0,5Kg
3
Assembly parts and cables
1 x IEC 2m Cable 1 x USB 5m Cable
1 x RJ45 7,5m Cable 1 x Foot for Base
24 x Screws for Extender
4
Package dimensions and weight
Shipping packages Shipping dimensions Weight
1. Sensor 50 x 50 x 20 cm 5 Kg
2. Base + Tower 60 x 60 x 35 cm 20 Kg
3. Extenders 165 x 28 x 28 cm 16 Kg
Total shipping weight: 41 kg.
The shipment is done in a total of 3 packages.
5
Assembly
1) Mount Extender Connector to Base
Use the the supplied screws to mount the connector. 2 on top and 2 on bottom
The supplied ‘Foot’ must be screwed into bottom under the Extender Connector
6
2) Connect Extender Rail
The Extender Rails are marked I, II and III. The number ‘I’ should be mounted to the base.
Use the supplied screwes to connets the rails. 2 screws on top and bottom for each rail.
The supplied little foam piece can be mounted on the last rail you choose to use. Its only used
to make your last Rail end look complete and has no fuctions.
Use 4 of the supplied screws to mount it.
III
II
I
7
Mount Tower to Base
Slide tower backwards onto the Base, like shown below
8
Connect the C-Plane Head to the RJ45 connector on top of the base with the supplied 50cm
RJ45 cable
C-Plane Head
RJ45 Connector
9
Level the system
The system must be levelled correctly to get correct measurement. To insure proper levelling
begin with the base unit and the move on to Rail I, II and then III.
Levelling is done by turning the feets, either from below or using an Allen Key from the top.
10
Mount Sensor
The Sensor should be mounted by sliding it on from the back end of the rail. Lift up the small
position pin in front of the Sensor to slide it on.
ATT: If the Sensor has been connected with the RJ45 cable to the Base, it may be necessary to
restart the software for the Sensor to be able to set the distance. Make sure to slide the Sensor
to a position where the position pin on the Sensor falls into place and locks the Sensor.
Altri manuali per BaseSpion
1
Indice
Altri manuali Viso Systems Strumento di misura
Viso Systems
Viso Systems LightSpion LIGSP001 Manuale utente
Viso Systems
Viso Systems LabSpion Manuale utente
Viso Systems
Viso Systems LabSpion Manuale utente
Viso Systems
Viso Systems VISO SYSTEMS Labarazzi Manuale utente
Viso Systems
Viso Systems LabSpion Manuale utente
Viso Systems
Viso Systems LightSpion Manuale utente
Viso Systems
Viso Systems LabFlicker Manuale utente
