AUDAC CS74 Manuale utente

Questo manuale è adatto per i seguenti modelli

1

Indice

Altri manuali AUDAC Altoparlanti

Manuali Altoparlanti popolari di altre marche

argon audio

argon audio IE20 Manuale utente

Denon

Denon SC-N7 Manuale utente

Gemline

Gemline Ace 3952 Manuale utente

Focal

Focal ON WALL 300 Manuale di istruzioni

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuale utente

SoundLogic

SoundLogic BCCS-6/6395 Manuale utente

Peavey

Peavey DTH 218 Manuale utente

Avantree

Avantree Pluto Air Manuale utente

Morel

Morel Integra Series INTEGRA OVATION 4 Manuale utente

Oppo

Oppo SONICA Manuale utente

Bose

Bose SoundLink Wireless Music System Manuale utente

Rocksteady

Rocksteady Stadium Manuale utente

Bowers & Wilkins

Bowers & Wilkins 4 Manuale utente

Sonance

Sonance SONOS OUTDOOR Series Manuale utente

Electro-Voice

Electro-Voice EVID FM4.2 Manuale utente

Pioneer

Pioneer XW-HTD630 Manuale utente

Onn

Onn BWA16AA002 Manuale utente

HP

HP GL313AA - USB Speakers PC Multimedia Manuale utente

PROFESSIONAL AUDIO EQUIPMENT

Ceiling Speaker CS74

Installation Guide

Ceiling

Speake

r

CS74

AUDAC

1

Installation Procedure

1) Cut a hole in the ceiling on the desired mounting location of the loudspeaker with a diameter of 167

mm. The included cutout template can be used for marking.

2) Provide the loudspeaker connection cable through the mounting hole.

3) Take the loudspeaker, and remove the front grill.

The front grill can be removed by rotating the mounting clips outwards and pushing them down. The

fixing screws will push the front grill out.

4) Pull the mounting clips up again, and rotate them inwards, making the speaker fit through the

mounting hole in the ceiling.

2

5) Connect the loudspeaker connection cable with the power tap connection block. On this connection

block, several connections can be made for different power taps. Depending of the desired power,

connections can be made for 8 Ohm Low impedance application, or 6 Watt / 3 Watt / 1.5 Watt for

100 Volt applications.

Press the locking mechanism of the desired power tap down, and insert the connection cable. After

releasing the locking mechanism, the speaker connection cable is connected to the loudspeaker or

transformer.

Always connect the common of the amplifier output to the C terminal, and the positive amplifier

output to the desired terminal. (8 ΩFor low impedance applications and the desired power terminal for

100 Volt applications).

6) Once the connections are made, the loudspeaker can be installed in the provided mounting hole. Insert

the speaker in the provided mounting hole, and use a screwdriver for tightening the fixing screws.

Once the screws are tightened by a quarter turn, the mounting clip will rotate outwards and will be

locked behind the ceiling. From this moment, the loudspeaker cannot fall out the ceiling. To make the

speaker equal with the ceiling, the fixing screws should be tightened.

7) Once the mounting screws are tightened, the front grill can be assembled to the loudspeaker.

On locations where high vibrations may occur, it is recommended to push the included small rubber

pieces into the groove where the grill fits in. This small rubber pieces makes sure that the grill won’t

come out by vibrations.

3