5
G141
INSTRUCTIONS FOR THE INSTALLER
Prior to installation, ensure that the local distribution
conditions(natureofthegasandgaspressure)andthe
adjustment conditions are compatible.The factory set
adjustment conditions for this appliance are stated on
the rating label,which is fitted to the back panel of the
appliance.
This appliance is not designed to be connected to a
combustion products evacuation device. It must be
installed and connected in accordance with current
installation regulations. Particular attention should be
giventotherelevantrequirementsregardingventilation.
ThisapplianceisfactorysettoburnNATURALGAS(G20),
category I2H+ (GB, IE) at 20mbar ONLY and cannot be
used on any other gas category.
GAS SAFETY (INSTALLATION & USE)
REGULATIONS
It is the law that all gas appliances are installed by
competent persons in accordance with the current
edition of the above regulations. It is in your interest
and that of safety to ensure compliance with the law.
In the UK, CORGI registered installers work to safe
standards of practice.
The cooker must also be installed in accordance with
BS 6172: 1990.
Failure to install the cooker correctly could invalidate
the warranty liability claims and could lead to
prosecution.
LOCATION
The cooker may be located in a kitchen, kitchen/diner
or a bed-sitting room, but not in a room containing a
bath or shower.The cooker must not be installed in a
bed-sitting room of less than 20 m3.
PROVISION FOR VENTILATION
The room containing the cooker should have an air
supply in accordance with BS 5440:Part 2:1989.
Theroom musthave anopeningwindow orequivalent;
some rooms may also require a permanent vent. If the
roomhas avolume between 5and 10 m3,it willrequire
an air vent of 50 cm2effective area unless it has a door
whichopensdirectlytooutside.Iftheroomhasavolume
of less than 5 m3, it will require an air vent of 100 cm2
effectivearea.Ifthereareotherfuelburningappliances
in the same room, BS 5440: Part 2: 1989 should be
consulted to determine air vent requirements.
