REV. H 10/12
F. QUIK-LOK INSTALLATION AND OPERATION
To mount Quik-Lok Clamp on Di-Acro No. 4 Bender for clockwise
forming, insert 3/8” dowel pins (K) and (K-1) in holes to bender base
casting. Bolt in position with 1/2-20 hex screws (L) and (L-1) inserted
from the bottom side of base.
To adjust for material size, radius of bend and clamping pressure;
loosen 1/2-20 hex screw (M) on clamp (O) and move slide assembly
(R) to the correct position and then tighten 1/2-20 hex screw (M).
To open Quik-Lok Clamp, move handle arm (W) to the right. To mount
Quik-Lok clamp for counter-clockwise forming, remove clamp
assembly from base by removing 3/8 hex screws (T-1) and (T-2).
Remove mounting plate from bender base by loosening 1/2-20 hex
screws (L) and (L-1). Press 3/8” dowel pins (K) and (K-1) through base
(U) and turn plate over so 3/8” dowel pins cab be inserted in holes (K)
and (K-2) then bolt in position with 1/2-20 hex screw (L). This will
place base (U) in a position 180° from its location in this photograph.
Bolt clamp assembly on base with 3/8” hex screws (T-1) and (T-2).
R M O U
W T-1 T-2 K-1 L-1 K L
