Dynojet Power Commander III Manuale utente

i420-411www.powercommander.com 2006-2007 Yamaha FZ1- PCIII USB - 1

2006-2007 Yamaha FZ1

Installation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

Parts List

1Power Commander

1USB Cable

1CD-ROM

1Installation Guide

1Power Adapter

2Power Commander Decals

2 Dynojet Decals

2 Velcro®Strip

1Alcohol Swab

You can also download the Power

Commander software and latest maps

from our web site at:

www.powercommander.com

The ignition MUST be turned

OFF before installation!

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Button Adjustment Display

Faceplate Buttons

USB Port

Expansion Port

1Remove the main seat and the passen-

ger seat.

2Prop the front of the fuel in the up

position.

3Lay the PCIII in the tail section tem-

porarily. Route the PCIII harness

under the tail section and go towards

the front of the bike.

4Locate the connector from the main

wiring harness to the

injector rail and uplug this

connector (Fig. A).

NOTE: This connector is grey in color.

5Plug the connectors from the PCIII in-

line of the stock wiring harness (Fig.

B).

6Bolt the fuel tank down into position.

7Remove the bolt on the left hand side

of thefuel tank bracket and loosen the

right hand bolt enough to route the

PCIII harness underneath it (Fig. C).

8Reinstall the bracket.

Fig. AFig. B

Fig. C

i420-411 www.powercommander.com 2006-2007 Yamaha FZ1- PCIII USB - 2

PCIII connectors

Stock connectors

Unplug this connector

Route the harness

underneath this bracket

PCIII harness

9Attach the ground wire from the PCIII

to the negative side of the battery

(Fig. D).

10 Install the PCIII in the rear

section of the trunk (Fig. E).

This bike does not have a flat surface

to allow you to use the supplied vel-

cro. The unit can just lay in the tail

section or if you are not using your

tool kit the PCIII can be secured using

the tool kit band.

11 Make sure all the wires are

routed properly.

12 Reinstall the main seat and the pas-

senger seat.

Fig. D

2006-2007 Yamaha FZ1- PCIII USB - 3

Fig. E

Ground wire from the PCIII.

i420-411 www.powercommander.com

Indice

Altri manuali Dynojet Accessori per motociclette

Dynojet

Dynojet Power commander III Manuale utente

Dynojet

Dynojet Power Commander FC Manuale utente