© 2020 Glenair, Inc. - 3/22 CAGE Code 06324 Printed in U.S.A.
GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497
818-247-6000 • FAX 818-500-9912 www.glenair.com
10
601-106 and 601-107
Operating Instructions
Adjust cut-o timer See Fig. 6
1. Do not alter factory setting, unless
necessary.
2. A small copper screw found on the
back of the tool handle (above the
reset button) adjusts the cut-o timing.
3. Using a small, standard screwdriver,
turn the screw clockwise to increase
the cut-o delay, and counter-clockwise
to decrease the cut-o delay.
Caution: Adjusting cut-o delay timing too short
will result in premature cut-o, and a loose clamp.
Note: Normal delay is between 1 and 2 seconds after shuttle stops cycling.
Threaded
Sleeve
Arm
Mounting
Pin
Knife
Blade
Screw #2
Screw #1
Replace worn/damaged cutter knife or blade (See Fig 7)
This procedure is easier to do if tool is connected to air supply.
1. Remove two button head cap screws (BHCS) with 1/16 hex keys. Two hex
keys will be needed to complete this step.
2. Push out two BHCS screws and threaded sleeve nuts using one of the 1/16
hex keys, then remove cuto knife by pushing mounting pin out.
3. When BHCS/threaded sleeves are
removed, lift cuto blade out of
tool head.
4. Assemble in reverse order
5. If needed loctite, low strength,
222, purple, can be applied to
BHCS screw.
6. Torque BHCS to 2-3 in/lbs.
Important: To order correct
replacement parts, locate tool
model number on tool head.
