ICP DAS USA M-7019Z Manuale utente

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

M-7019Z

10-channel Universal Voltage Input & Current

Input, thermocouple input Module

Quick Start Guide

Product Website:

http://www.icpdas-usa.com/m_7019z.html

http://www.icpdas-usa.com/dcon_utility_pro.html

1. Introduction

M-7019Z is an RS-485 interface and 10-channel thermocouple input module. The

analog input range is software selectable and supports +/-15 mV, +/-100 mV, +/-150mV,

+/-500 mV, +/-1 V, +/-2.5 V, +/-5 V, +/-V10, +/-20 mA, 0 ~ 20 mA, and thermocouple of

type J, K, T, E, R, S, B, N, C, L, M, and LDIM43710. I-87019ZW uses external terminal

design, and takes thermocouple temperature output consistency.

2. Terminal Assignment

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

3. Block/ Wiring Diagram

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

M-7019Z Jumper Settings

The M-7019Z can accept current inputs from –20mA to 20mA. No external resistor

required but the corresponding jumper must be shorted. The following figure shows the

jumper positions.

4. Default Settings

Default settings for the M-7017, M-7018 and M-7019 series modules are:

▫Protocol: Modbus RTU

▫Module address: 01

▫Analog input type:

Type 08, -10V to 10V, for the M-7017 and M-7019 series

Type 1B, -150V to 150V, for the M-7017R-A5

Type 0D, -20mA to +20mA for the M-7017C and M-7017RC

Type 05, -2.5V to 2.5V, for the M-7018 series

▫Baud Rate: 9600 bps

▫Filter set at 60Hz rejection (Not used by the M-7019R, firmware version B2.6 and

earlier)

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

5. Configuration

To install the module, follow the steps below:

1. Connect the thermistor analog input.

2. Connect the module to the RS-485 network using the DATA+ and DATA- terminals. If

the host is only equipped with an RS-232 interface, then an RS-232 to RS-485

converter will be required.

3. Connect the module to the power supply using the +Vs and GND terminals. Note that

the voltage supplied should be in the range of +10 to +30V DC.

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

4. Open DCON utility pro

click on COM port(first icon).

It can select multi-options such as Baud Rate, Protocol, Checksum, and Format to

search module. The default settings for the module can be found in Section 3. Click OK

after selecting the COM port setting.

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

5. DCON utility pro will search for the selected COM port according the setting

previously set. DCON Utility Pro supports DCON and Modbus protocol for all ICPDAS

and the others modules.

6. Configuration I/O module setting on PC

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

7. For M-7000 modules using the Modbus RTU protocol, configure the module using the

following functions.

Sub-function 04h of Function 46h, see user manual Section 3.3.2

Sub-function 06h of Function 46h, see user manual Section 3.3.4

Sub-function 08h of Function 46h, see user manual Section 3.3.6

For M-7000 modules using the Modbus RTU protocol, use Function 04h to read the

data from the input channels. See user manual Section 3.2 for details.

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717

8. If user doesn’t know command, user can select Address and ID, it will show some

refer commands as below. User can select necessary command to test or debug

modules.

Indice

Altri manuali ICP DAS USA Unità di controllo

ICP DAS USA

ICP DAS USA I-8094 Manuale elenco delle parti

ICP DAS USA

ICP DAS USA I-7088 Manuale utente

ICP DAS USA

ICP DAS USA ET-7218Z Manuale utente

ICP DAS USA

ICP DAS USA M-7064 Manuale utente

ICP DAS USA

ICP DAS USA PROFI-5045 Manuale utente

ICP DAS USA

ICP DAS USA PM-3133-RCT Series Manuale utente

ICP DAS USA

ICP DAS USA I-7063 Manuale utente

ICP DAS USA

ICP DAS USA ECAT-2016N Manuale utente

ICP DAS USA

ICP DAS USA 7188EN Guida all'installazione

ICP DAS USA

ICP DAS USA ET-7083 Manuale utente

ICP DAS USA

ICP DAS USA WF-2017 Manuale utente

ICP DAS USA

ICP DAS USA I-8123W Guida all'installazione

ICP DAS USA

ICP DAS USA GPS-721-MRTU Manuale utente

ICP DAS USA

ICP DAS USA ET-2260 Manuale utente

ICP DAS USA

ICP DAS USA I-7016 Manuale utente

ICP DAS USA

ICP DAS USA ZT-2570 Manuale utente

ICP DAS USA

ICP DAS USA EIP-2060 Manuale utente

ICP DAS USA

ICP DAS USA LP-8 21 Series Manuale utente

ICP DAS USA

ICP DAS USA M-7041D Manuale utente

ICP DAS USA

ICP DAS USA M-7067D Manuale utente

ICP DAS USA

ICP DAS USA tSH-734 Manuale utente

ICP DAS USA

ICP DAS USA DS-700 Series Manuale utente

ICP DAS USA

ICP DAS USA tPET-P6 Manuale utente

ICP DAS USA

ICP DAS USA I-7055D Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente