Envelop the blade before storage. Keep children away from it.
Never remove the machine’s guard.
Clean and maintain the tool before storage . Bring maintenance after each use
according the instructions of this manual. Improper maintenance can reduce
the lie of the tool, bring bad results and wear the tool and its accessories.
Check the tool before and after use. Check for loose fasteners, fuel leaks and
damaged parts, such as cracks in the cutting attachment. If the tool is damaged,
if parts are missed or meet some dysfunctions, do not use the tool and bring it to
a service agent for inspection and reparation.
Check the tool after dropping or other impacts to identify any significant
defects; if any defects are observed, stop to use the tool and bring it to a service
agent for inspection and reparation.
Do not store in a closed area where fuel vapors can reach an open flame from hot
water heaters, furnaces, etc. Store in a locked, well-ventilated area only.
Never place the machine in any places where there are flammable materials
(dry grass, etc.), combustible gasses or combustible liquids.
When the machine is placed in storage for a long time, drain fuel from the fuel
tank and carburetor, clean the parts, move the machine to a safe place and
confirm that the engine is cooled down.
Emission of exhaust gases
National regulation can restrict the use of the machine.
Never modify a trimmer or cutter in any way.
Improper use of the machine can cause SERIOUS OR FATAL PERSONAL
The engine exhaust form this product contains chemicals to cause cancer,
birth defects, of other reproductive harm.
Check regularly that the cutting attachment stops turning when the engine
2.1.2 Kickback and Related Warnings
● Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad,
brush or any other accessory. Pinching or snagging causes rapid stalling of the
rotating accessory which in turn causes the uncontrolled power tool to be forced in
the direction opposite of the accessory’s rotation at the point of the binding.
● For example, if an abrasive wheel is snagged or pinched by the work piece, the
edge of the wheel that is entering into the pinch point can dig into the surface of the
material causing the wheel to climb out or kick out. The wheel may either jump
toward or away from the operator, depending on direction of the wheel’s movement
at the point of pinching. Abrasive wheels may also break under these conditions.
●Kickback is the result of power tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below:
