Réf.95120 3/3
MAINTENANCE
Replacing the blade (ref 095122)
1. Loosen the locking knob (A).
2. Lower the blade by turning the adjustment knob (B) until it turns freely.
3. Pull the blade holder assembly (F) out of its housing.
4. If only one side of the blade is worn: turn the whole assembly around
If both side are worn: unscrew the retaining screw (G) by two turns, replace the blade
and retighten the retaining screw, (G) ensuring the parts are correctly aligned.
5. Insert the blade holder in its housing and raise it by turning the knob.
Precautions
The PICO must always be stored in its protective cover to avoid scratching the sole plate
(rubbing surface).
Always remove any glue residue from the sole plate and the guide after use.
THE GROOVING TECHNIQUE
Consists in cutting a groove along a joint between two floor covering elements glued edge-to-edge
(less than 1 mm)
Depth of groove:
for homogeneous floor coverings: 2/3 of the thickness.
for non-homogeneous floor coverings: only the wear layer.
Before grooving After grooving
ACCESSORIES:
REF. 95122 – SPARE BLADES / Pack of 10
CBlade
FBlade holder
GRetaining screw
BLocking
knob
AAdjustment
knob
