60°
POINT MASTER
Model No.：K2-32/K2-20
＜
comb.
＞
Thank you for purchasing the Point Master scribe.
For proper use, please read this manual thoroughly and follow the directions.
INSTRUCTION MANUAL
Do not over-tighten when mounting to milling machine.
If Chuck is tightened too much, it may prevent
retraction.
Bring milling machine spindle to a complete stop
before using.
Use only for intended purpose.
●
●
●
①Mount on the milling machine
chuck.
②Set the tip 2 to 3mm below
workpiece surface, and hold up
the scribe by hand to enter the
workpiece.
※Replacement scribe with 85°
tip angle available for tapered
or stepped surfaces.
Mount onto milling machine for marking of workpiece.
High precision scribing can be done easily and
efficiently without the need for height gauges or
machinist square.
●
●
■
PART NAMES・DIMENSIONS
■
HOW TO USE
※Downhill
Milling Machine
Scribe Tool
ModelNo. Ｋ２−３２
32ｍｍ
146ｍｍ
10ｍｍ
Body / Scribe: Tool Steel
Scribe Tip: Carbide
5ｍｍ
0.02ｍｍ
Ｋ２−２０
20ｍｍ
510ｇ280ｇ
60°
18ｍｍ
3.5〜4Ｎwhen compressed10ｍｍ
■
SPECIFICATIONS
■
APPLICATION・FEATURES
CAUTION
※Valuesshownareapproximate.
※Dimensionsshownareapproximate(mm).
60
(146)
(60)
18
φ10
K2-32 : φ32
K2-20 : φ20
Retraction
Scribe（tip angle: 60°）
※Carbide Tip
※Replacement Scribe
with 85° tip angle also
available.
Tip P/N…60°：PMC-60
85°：PMC-85
Shank
2〜3ｍｍ
< 10ｍｍ
Click-on
to install
Workpiece
Workpiece
Scribe
Hex Screw
※Click-on type replaceable Scribe
clicks on for installation or removal.
※Adjust hex screw (3mm) if Scribe is
not held, or if motion is not smooth
for full range.
Do not tighten too much orScribe will
not retract.
Shank Diameter
Tip Angle
Length
Scribe Diameter
Retraction Distance
Scribe Force
Concentricity
Steel Ball Diameter
Mass
Material
※Model K2-32 shown.
Scribing direction
Niigata seiki Co., Ltd.
5-3-14, Tsukanome, Sanjo, Niigata, Japan, 955-0055
Tel. : +81-256-33-5522 Fax. : +81-256-33-5518
URL http://www.niigataseiki.co.jp
