Solo 110 Telescopic Access Pole Manuale utente

Solo 110 Telescopic Access Pole &

Solo 111 Extension Pole

User

Instructions

www.solo-tester.com

Important

Information

Symbols

The following symbol is used throughout this User Manual

and on the product.

This symbol on the product indicates that

there is a safety hazard or an operation

requiring care to avoid damage to the product

or environment. You must read the

appropriate sections of the User Manual to

understand the nature and severity of all the

potential hazards present and the action you

must take.

• Never allow an extended pole section to collapse uncontrolled. Risk of injury and equipment damage.

• Do not create trip hazards by leaving poles unattended in public spaces and avoid leaving poles extended when not in

use (against walls, across desks etc.). Risk of injury and equipment damage.

• Solo poles are not specied for use in high voltage areas. Risk of injury and equipment damage.

• When working at height it is recommended that a competent person carries out a suitable risk assessment. This will

identify any risk to the user and/or the environment, or other safety measures, and hence any need for Personal

Protective Equipment (PPE).

• Do not use Solo poles if unable to control their use properly e.g. when fatigued. Risk of injury and equipment damage.

It is recommended that Solo poles are inspected before and after use and if any signs of damage, abnormal wear or

modication are found, the poles should not be used.

Warning

Caution

• Solo poles are designed only to be used with Solo and

Testire product ranges.

• Read this User Manual completely before using Solo

Access Poles

• Keep this User Manual - Save all safety and operational

instructions for future reference.

• Take note of the Warnings - Read carefully and follow

all warning labels on the product and those described

in this User Manual.

• Further product support is available from:

solo-tester.com/support

email: [email protected]

T: +44 (0) 1707 282760

www.solo-tester.com 3

3.5M

4.5M

Solo 110 1.7M

Solo 111 0.5M

Testire Solo 365 Solo 460 Solo 200Solo 330/332 Solo 423/424

4www.solo-tester.com

Using

Solo Access Poles

Figure 1

• Solo poles should always be held vertically when

raising or lowering. Ensure that all extension poles

and test tool buttons are locked into position before

extension and use. (Fig.1)

• When using Solo 111 extension poles in conjunction

with Solo 110 telescopic pole, the telescopic pole

should be at the shortest length, i.e. not extended,

before attaching or removing the Solo 111 extension

pole(s) or tool.

• No more than 3 x Solo 111 extension poles should

be used at the same time (see General

Recommendations for height & angle advice).

• When lowering, always hold in the vertical. Lower

telescopic sections rst, before removing Solo 111

extensions.

• When lowering telescopic poles, rest the base of the

pole on the oor and depress the locking button,

while lowering the upper sections with the other

hand.

General Recommendations

The maximum working height using Solo 110 & Solo 111

poles is 4.5 metres for Solo and Testire.This is achieved

using 1 x Solo 110 telescopic pole and a maximum of 3

x Solo 111 extension poles. It is recommended to stand

directly under the detector (pole vertical).

If vertical working is not possible, do not exceed 3.75m

reach and stand no more than 1 metre away from a point

directly beneath the detector. (Fig. 2)

Figure 2

Solo & Testire

1 x Solo 110

3 x Solo 111

Max

‘Click’

Solo & Testire

1 x Solo 110 +

3 x Solo 111

Max

4m Max.

4.5m

1m Max

www.solo-tester.com

Figure 5

Figure 4

Figure 3

H O

Tips to prevent user fatigue

• Stand with one foot half a stride ahead of the other to

increase balance and reduce strain.

• Where possible, share testing workload with others.

• Alternate using the poles between the left and right

hand side of the body.

• Take regular breaks.

Use with Testire 25 Remote Control (Fig. 3)

Storage and Maintenance

Solo poles which are not in use should always be returned

to protective storage bag. (Fig. 4)

Solo poles can be wiped clean using a damp cloth. Only

mild detergents or water may be used. (Fig. 5)

Solo poles are covered by a limited lifetime warranty.

Accidental damage or user modication will invalidate this

warranty.

Disposal (End of Life Statement)

Solo poles are manufactured from breglass (GRP) and are

classied as Non-Hazardous Waste and can be disposed of

at municipal or industrial landll when in compliance with

local regulations.

Do not burn, incinerate, or cut into pieces. Dispose as a

whole.

Warning

Use of the Testire 25 Remote Control in

conjunction with any of the Solo poles requires

the user to momentarily release one hand

from the pole to activate the remote control.

• Extra care should be taken when

doing this.

• Read the Testire 25 User Manual

prior to use.

LI400036-1

As our policy is one of continuous improvement, details of products described within this publication are subject to change without notice. All information provided

here is believed to be correct at the time of going to press. Every effort has been made to ensure the accuracy of information which is provided in good faith but

nothing contained herein is intended to incorporate any representation or warranty, either express or implied or to form the basis of any legal relations between the