2
Phone: (800) 597-3921 or (317) 803-8000 • Fax: (317) 803-8001
Important – Cautions & Warnings
The Model 00400 has been constructed using the lat-
est technology and is extremely safe and easy to op-
erate. Despite that, there is sll some danger if these
units are operated incorrectly and/or by untrained
personnel.
Pay parcular aenon to the following Cauons and
Warnings marked with the “Aenon” and “Danger”
symbols. Failure to follow safe operang pracces
may cause injuries, death, or damage to the machine,
and may void your manufacturers’ warranes.
•
Before aempng to use the unit you must have
read and fully understood this Owners Manual. Keep
this Owners Manual within easy reach of operang
personnel.
•
Visually inspect the unit, power cord, and accessory
items for any signs of wear or damage before
operang the unit. Do not use the unit if there is
any sign of damage, or if the unit is not performing
normally.
•
Never operate the machine without the correct
inducon stop ring in place on the inducon head. Do
not allow any part of the inducon head to contact
the tool holder or cung tool during operaon or
damage to the machine may occur.
•
Do not wear rings, bracelets, or other metallic objects
while operang the machine. Metallic objects may
heat up very quickly when near the inducon head
during operaon.
•
Use the provided thermal insulated glove whenever
handling tools or toolholders. Never try to handle
hot tools or toolholders unl the cooling cycle is
complete.
•
If the machine is moved from a cold environment
to a warm one, wait two hours before operang
to prevent condensaon build-up from causing
electronic system errors.
•
Persons with heart pacemakers may not operate the
machine, and must maintain a minimum safe distance
of 6 feet (2 meters) from the machine at all mes.
•
Cung tools have sharp edges. Handle with cauon.
•
Do not obstruct the area above the inducon head
or place items under or near the path of the tool
holder. This could create an unsafe condion during
the automated movement of the tool holder.
•
Do not bypass EOT switches or obstruct the movement
of the EOT plates. This could create a pinch hazard.
•
The power cord provided must be plugged into the
correct NEMA L16-20R outlet. Operang the unit
while improperly connected or at the wrong voltage
may damage the unit and could possibly cause death
or injury.
•
Posion the power cord so it cannot be damaged by
fork trucks or other equipment, or cause a tripping
hazard for personnel.
•
Do not operate the machine in a wet environment
where exposure to coolant or spills are likely to occur.
Electric shocks or damage to the machine may occur.
•
Never operate the machine around ammable
materials, or fumes. Do not use ammable liquids
or aerosols to clean tool holders. Never expose the
machine or hot tools to combusble materials.
•
Never open the machine or aempt repairs or you
will VOID the manufacturer’s warranty. Dangerous
residual voltage is inside that may cause death or
injury.
•
Unauthorized modicaons or changes to the
ShrinkSTATION machine will VOID your manufacturer’s
warranty. Do not try and service your unit yourself.
Techniks can provide any necessary repairs or
maintenance. Do not modify or disable the built-in
safety features of the machine.
•
Turn o the power switch and disconnect the power
cord from the outlet before cleaning, servicing, or
storing the unit.
•
Do not operate this machine, if the EOT switches are
not working properly.
Make sure you read, understand and follow these
Cauons and Warnings, as well as the complete
technical notes, setup and operaon instrucons
before installing and using your machine.
