FF-MM-403-REV - 00
Page 3
Operation and Maintenance Guide Pneumatic Flexible Descaler TPFD75
Technical Data
IMPA Number
Equivalent Model No Max. Air
Consumption
No Load
Speed R.P.M Weight, Kgs
59 12 51 TPFD 75 10 cfm 5000 21
Introduction
Teryair Pneumatic descaling machines are light and easy to handle, but rigidly constructed tools.
ey eciently handle heavy duty scaling. Required air pressure is 0.59 Mpa (6kgf/cm²).
Safety Instructions
Wear appropriate personal protective equip-
ments including safety goggles, foot wears, ear
defenders facemasks & hand-gloves.
Do not apply excessive load on the stieners
while working.
Do not store the sha in incorrect method ot it
gives deformation to inners. e shas should
be stored straight in racks with proper at sup-
port at support of wooden planks.
Please check the hose connection prior to start-
ing the Pneuamtic Flexible De Scaler.
Do not modify this equipment.
Do keep hand & clothing away from moving
parts.
Do not allow the equipment to run unattended.
Flexible De scaler should be store in dry envi-
ronment.
ese tools may cause Hand - arm vibration
syndrome injury if there is not adequately
managed. We advice you to carry out a risk as-
sessment and to implement measures such as;
limiting exposure time (i.e. actual trigger time,
not total time at work) job rotation, ensuring
the tools are used correctly.
Air Supply
Tool should not be operated at air pressure
below 5.5 Bar (80 PSI) and above 6.9 Bar (100
PSI).
e correct oprating pressure is 6.2 Bar(90
PSI).
Ensure that only 3/8” (10 mm) bore airline is
used abd all couplings are thight, leakproof and
in good condition. e air should be clean, dry
lubricated. Install a FRL units as close as opera-
tion will permit.
Forward
At the outset we sincerely thank you choosing
our product. We at teryair always believe in
oering high quality products the
most reasonable prices. is belief has helped us
to innovate and incorporate new ideas and thus
enjpy a high degree of customer satisfaction.
is manual is designed keeping in mind all the
requirements of the customer in knowing the
prodcut its use.
is product is almost maintenance free. Only
continous air supply at 6.33 kg/cm2 is required.
Operating Instructions
Place Pneumatic Air Motor with trolley on oor.
Open Hose assembly (334 9728).On one of the
ends-rotary socket has female threads. Screw on
ths scoket on motor sha. Tighten it fully. en
screw on xing adaptor on motor end shield.
With little force this will t tight on motor. en
open Tool box and select which of these assem-
biles do you prefer to use.
Following is the guideline for
selection
A. For Heavy rusting - Use No.1 H.D.Tool
(59 12 55)
B. For Light rusting - Use either No.2
L.G.Brush (59 12 60)
