Rev. 20211001
4
iBoard
®
STEP 5
Move to the Mounting locations 2 & 4. Repeat Steps 2-4 to
install Support Brackets and Mounting Brackets. Do not fully
tighten at this time.
STEP 6
Move to the location 3. Drill (2) 5/16” holes on pinch weld, (Fig
1). And then attach the Support Bracket to the drilled holes with
(2) M8X1.25-20mm Hex Bolts, (4) M8 Flat Washers, (2) M8
Nylon Lock Nuts, (Fig 5).
Attach the Mounting Bracket to the installed Support Bracket
with (1) M8X1.25-20mm Hex Bolt, (2) M8 Flat Washers, (1) M8
Nylon Lock Nut, (Fig 6). Adjust the Mounting Bracket properly.
Mark and drill (1) 6mm hole on rocker panel. Attach the mount-
ing Bracket to the drilled hole with (1) ST6.3-25mm Hex Self
tapping Screw, (Fig 6).
STEP 7
Select a Running Board. Slip (4) M6x1-20mm Square Head
Bolts into each bottom channel (Fig 7). Carefully position the
Running Board onto the (4) Mounting Brackets.
IMPORTANT: Do not slide the Running Board on the Brackets
or the bottom surface of the board will be damaged. Attach the
Running Board to each Mounting Bracket with (2) M6X1-20mm
Square Head Bolts, (2) M6 Large Flat Washers and (2) M6 X1
Nylon Lock Nuts (Fig 8). Do not fully tighten at this time.
(Fig 7) Slip M6X1-20mm Square Head Bolts Into
The Bottom Channels
M6X1-20mm Square Head Bolts
Support Bracket
Front
(Fig 5) Support Bracket Installation on Location 3
(1) M8X1.25-20mm Hex Bolt
(2) M8 Flat Washers
(1) M8 Nylon Lock Nut
(1) ST6.3-25mm Hex Self Tapping Screw
Note: Drilling is required on rocker pane for in-
stalling the ST6.3-25mm Hex Self Tapping Screw.
(Fig 6) Mounting Bracket Installation on Location 3
Support Bracket
Mounting Bracket
Front
(2) M8X1.25-20mm Hex Bolts
(4) M8 Flat Washers
(2) M8 Nylon Lock Nuts
