Stratus SAE-C12X Guida

Installaon & Operaon

Maintenance & Instrucons

STRATUS 2 Post Overhead Li Installaon & Operaon & Maintenance Instrucons

Model No.: SAE-C12X

2 Post Overhead Li

Single (1) Point Manual Release

Liing Capacity:12000LBS

Important Note

1.This equipment can not be installed, operated or repaired without reading instrucons.

2.Electricty must be hooked up by cered electrician.

3.Do not use this equipment beyond its rated capacity.

CONTENTS

1-Equipment descripon

…………………………………………………………………………………………………

1.1-Descripon ……………………………………………………………………………………………………………3

1.2-Technical specicaons………………………………………………………………………………………………3

1.3-Installaon requirement………………………………………………………………………………………………5

2-Specicaons of concrete………………………………………………………………………………………………6

3-Installaon steps…………………………………………………………………………………………………………7

4-Operaon and use………………………………………………………………………………………………………18

4.1-Operaon ……………………………………………………………………………………………………………18

4.2-Raising Liing…………………………………………………………………………………………………………18

4.3-Stopping ………………………………………………………………………………………………………………18

4.4-Lowering ………………………………………………………………………………………………………………18

5-Safety ……………………………………………………………………………………………………………………18

5.1-Important Reminder…………………………………………………………………………………………………18

5.2-Vehicle Posion………………………………………………………………………………………………………19

5.3-Risk of Vehicle falling o from the li…………………………………………………………………………19

6-Maintenance ……………………………………………………………………………………………………………19

6.1-Every Month …………………………………………………………………………………………………………19

6.2-Every 3Month ………………………………………………………………………………………………………19

6.3-Every 6Month ………………………………………………………………………………………………………20

6.4-Every 12 Moth ………………………………………………………………………………………………………20

7-Troubleshoong guide …………………………………………………………………………………………………20

8-Structure and Parts List…………………………………………………………………………………………………21

8.1-Main column assembly……………………………………………………………………………………………21

8.2-Sun-column assembly………………………………………………………………………………………………21

8.3-Block assembly………………………………………………………………………………………………………22

8.4-Cross arm assembly…………………………………………………………………………………………………22

8.5-Cylinder assembly……………………………………………………………………………………………………23

8.6-Three-secon arm assembly………………………………………………………………………………………23

8.7-Main column safety lock assembly………………………………………………………………………………24

8.8-Secondary column safety lock assembly…………………………………………………………………………25

1.-Equipment Descripon

1.1-Descripon

This 2 Post Overhead Li is an advanced car maintenance equipment, mainly used for automove repair and

maintenance.

1.2-Technical Specicaons

Model SAE-C12X

Liing capacity 12000lbs;5500KG

Overall Hight 173 3/8″;4403mm

Overall Width 155 1/8″;3940mm

Liing height 74 13/16";1900mm

Min. height 4 5/8";118mm

Column inside 129 15/16";3300mm

Drive through 115 11/16";2939mm

Liing me About 60 sec.

Lowering Time About 40 sec.

Column thickness of steel 6.0mm

Carriage thickness of steel 6.0mm

Arms thickness of steel 7.75mm

Arm range 35 1/16"-70 7/8";890-1800mm;

Diameter of cable Φ9mm

Voltage 220V

Power 3.0Kw/4Hp

Frequency 60Hz

Phase 1Ph

Breaker 30A

Hydraulic oil 3-5 Gallons AW46/AW32

Shipping Size 118"×44″×28";2997×1118×712mm

Equipment weight 2360lbs/1071KG

Installaon( See Fig 1 )

FIG 1

Features (See Fig 2)

FIG 2

1.3-Installaon requirement

Tools required

Name

Picture

Rotary hammer drill(Φ19)

carpenter's chalk

Hammer

Screw Sets

Level bar

Tap measure

English spanner(12")

Pliers

Ratchet spanner with socket(28#)

Socket head wrench(3#,5#,8#)

Lock wrench

Wrench set(10#,13#,14#,15#,17#,19,24#,27#,30#)

2-Specicaons of concrete ( See Fig 3 )

Specicaons of concrete must be adhered to the specicaon as following. Failure to do so may result in li and/or

vehicle falling.

◇Concrete must be thickness 200mm minimum and without reinforcing steel bars, and must be completely dry

before li installaon.

◇Concrete must be in good condion and must be of test strength 3500psi(245kg/cm²)minimum.

◇Floor must be level with no cracks or holes.

Steps of installaon

◇Locaon of installaon

Check and insure the installaon locaon( concrete, layout, space size etc.) is suitable for li installaon.

◇Use a carpenter's chalk line to establish installaon layout of baseplate( See Fig4).

FIG 3

FIG 4

3-Installaon steps

Step 1:Check the pats before assembly

Packaged li and hydraulic power unit( See Fig 5 )

Step 2:Move aside the parts and check the parts according to the shipment parts list (See Fig 6).

FIG 5

FIG 6

Step 3: Spare parts in the accessories box.

Serial

number

Name Photo Parameter Quanty

1Arm sha Φ40×250L 4

2Arm sha xing screw

Countersunk Hexagon Screw M10×15L 4

3Arm boom pad Φ70mm 4

4Increased set Φ60×100L 4

5Heightening bracket 2

6Heightening sleeve bracket xing

screw

Hexagon socket screws M8×10L 2

7An-collision tape 2

8An-collision rubber strip xing screws

Hexagon socket screws M8×30 4

9Power unit frame 1

10 Power unit frame xing screws

Hexagon socket screws M10×16L Each 2

11 Power unit xing screws

Hexagon Screw M8×25L Each 4

12 Manual unlocking lever M10 Each 1

13 Safety lock release cable 1

14 Wire rope U-shaped chuck M3 2

15 Expansion screw

M20×160L 14

Serial

number

Name Photo Parameter Quanty

16 Plasc gasket 15

17 Plasc cable e 30

18 Main column upper limit switch 1

19 Main column upper limit switch xing screw Phillips round head screws M5×10L 2

20 Upper limit plate and limit switch M4×10 and M4×25 1

21 Upper limit board 1

22 Upper limit plate xing screw Hexagon Screw M10×20L Each 4

23 Two cross arm connecng screws Hexagon Screw M8×20L Each 6

24 Two-secon cross arm end xing screws Hexagon Screw M10×25L Each 8

25 Heightening secon and column connecng

screw

Hexagon socket screws M10×12L Each 16

26 Wire rope support frame at the upper end of

the heightening secon

27 Fixing screws for the upper wire rope sup-

port frame of the heightening secon

Hexagon socket screws M5×10L 4

28 Plasc buckle cover xing screw Phillips round head screws M6×8L 8

29 Increased fuel-saving pipe pressure pocket 6

30 Increased the fuel-saving pipe pressure pock-

et xing screw

Hexagon socket screws M6×10L Each 12

31 Block rubber cover 2

32 Locking and unlocking rope seat assembly

accessories

33 User’s manual 1

Step 4: Install anchor bolts

Posion the columns on the installaon layout of baseplate. Install the anchor bolts. Check the columns plumbness

with level bar, and adjusng with the shims if the columns are not vercal. Do not ghten the anchor bolts (See Fig 7).

Note: Anchor bolts driven into the ground at least 150mm.(See Fig 8)

FIG 8

FIG 7

Indice

Altri manuali Stratus Sistema di sollevamento

Stratus

Stratus SAE-C10C Guida

Stratus

Stratus SAE-C10P Guida

Stratus

Stratus SAE-C9P Guida

Stratus

Stratus SAE-F12X Guida

Stratus

Stratus SAE-P166M Guida

Stratus

Stratus SAE-S66M Manuale utente

Stratus

Stratus SAE-P48 Guida

Stratus

Stratus MS9000XT Manuale utente

Stratus

Stratus SAE-F10S Istruzioni per l'installazione

Stratus

Stratus SAE-F10P Guida

Stratus

Stratus SAE-UT8000 Guida

Stratus

Stratus SAE-P410 Manuale utente

Stratus

Stratus SAE-UT9000 Guida

Stratus

Stratus SAE-C12XE Guida

Stratus

Stratus SAE-C10XE Guida

Stratus

Stratus SAE-C14X Guida

Stratus

Stratus SAE-F14X Guida

Manuali Sistema di sollevamento popolari di altre marche

morse

morse 82H-124 Manuale utente

Braun

Braun NL955 Series Manuale utente

haacon

haacon 1889.10 Manuale utente

Protekt

Protekt AT 252 Manuale utente

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Manuale utente

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Manuale utente

Genie

Genie Z-60/34 Manuale utente

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Manuale utente

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Manuale utente

Custom Equipment

Custom Equipment Hy-Brid 3 Series Manuale di programmazione

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Manuale di programmazione

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Manuale di programmazione

BERG

BERG BeNomic EasyLeaf Manuale utente

Powermate

Powermate LiftGate LG-3 Manuale utente

Snorkel

Snorkel TM12 Series Manuale utente

Terberg

Terberg OMNIDEKA Manuale utente

Harmar Mobility

Harmar Mobility AL625 Istruzioni operative

Rotary

Rotary SPO16 Manuale utente