SIIG NN-E20022-S1 Manuale utente

DP FireWire PCIe

Installation Guide

04-0540C

Introduction

The DP FireWire PCIe easily adds FireWire

connectivity to your PCIe equipped desktop.

Features and Benefits

• Provides3FireWireports(6-pin)formultiple

device connections

• Compliant with PCI Express base

specification 1.0a

• Compliant with 1394a-2000 and 1394-1995

standards

• Supports data transfer rates of 100, 200,

400Mbps

• Spare enhanced low profile bracket is

included to work in low profile chassis

• Works with DV camcorders, hard disk,

removable drives, scanners, digital cameras

and other FireWire audio/video devices

System Requirements

• PCI Express-enabled PC or Mac®

desktop

with an available PCI Express slot

• Windows® 8 (32-/64-bit) / 7 (32-/64-bit) /

Vista (32-/64-bit) / XP (32-/64-bit) / Server

2003 & 2008 (32-/64-bit) / Server 2008 R2

/ 2000

• Mac OS X v10.4 or later

Package Contents

•DP FireWire PCIe

• Spare enhanced low profile bracket

• "Y" split power cable

• Installation guide

Figure 1

FireWire ports

Power

connector

Internal FireWire

port

Layout

Hardware Installation

Note:Forlowprofilesystems,replacethecurrently

mounted full height bracket with the included

low profile bracket.

General instructions for installing the card are

provided below. Since the design of computer

cases and motherboards vary, refer to your

computer’s reference manual for further

information, if needed.

Static Electricity Discharge may permanently

damage your system. Discharge any static

electricity build up in your body by touching

your computer case for a few seconds. Avoid

any contact with internal parts and handle cards

only by their external edges.

1. Turn OFF the power to your computer.

Unplug the power cord and remove your

computer cover.

2. Remove the slot bracket from an available

PCIe slot.

3. Carefully align the card to the selected PCIe

slot push the board down firmly, but gently,

until it is well seated.

4. Connect the system power source to the DP

FireWire PCIe Power connector (use the

included "Y" split power cable, if needed).

5. Replace the slot bracket holding screw to

secure the card.

6. Replace the computer cover and reconnect

the power cord.

Driver Installation

Please make sure the board is installed before

proceeding with driver installation.

Windows

Windows 8 / 7 / Vista / XP / Server 2003 & 2008

/ Server 2008 R2 / 2000 will automatically detect

and install the correct driver for the DP FireWire

PCIe. No driver installation is needed.

To Verify Windows Installation

1. Right click Computer or My Computer,

then click Manage.

For Windows 8 / 7 / XP / 2003: Right click

Computer or My Computer, click Manage,

click Device Manager.

For Windows Vista: Right click Computer,

click Manage, click Continue, click Device

Manager.

For Windows Server 2008 / Server 2008 R2:

Right click Computer, click Manage, double

click Diagnostics, click Device Manager.

2. Double click 1394 Bus Controller or IEEE

1394 Bus host controllers, a VIA 1394

OHCI Compliant Host Controller should

be displayed.

Mac OS X

Mac OS will automatically detect and install the

correct driver for the DP FireWire PCIe. No

additional driver installation is needed.

To Verify Mac OS Installation

1. Open System Profiler.

2. Under Hardware, click PCI Cards, an IEEE

1394 Open HCI card should be displayed.

Technical Support and Warranty

QUESTIONS? SIIG’s Online Support has answers! Simply visit our web site at

www.siig.com and click Support. Our online support database is updated daily with

new drivers and solutions. Answers to your questions could be just a few clicks away.

You can also submit questions online and a technical support analyst will promptly

respond.

SIIG offers a 5-year manufacturer warranty with this product. This warranty covers the

original purchaser and guarantees the product to be free of any defects in materials or

workmanship for five (5) years from the date of purchase of the product.

SIIG will, at our discretion, repair or replace (with an identical product or product

having similar features and functionality) the product if defective in materials or

workmanship. This warranty gives you specific legal rights, and you may also have other

rights which vary from state to state. Please see our web site for more warranty details.

If you encounter any problems with this product, please follow the procedures below.

A) If it is within the store's return policy period, please return the product to the store

where you purchased from.

B) If your purchase has passed the store's return policy period, please follow the steps

below to have the product repaired or replaced.

Step 1: Submit your RMA request.

Go to www.siig.com, click Support, then REQUEST A PRODUCT REPLACEMENT

to submit a request to SIIG RMA or fax a request to 510-657-5962. Your RMA request

will be processed, if the product is determined to be defective, an RMA number will

be issued.

Step 2: After obtaining an RMA number, ship the product.

• Properly pack the product for shipping. All accessories that came with the

original package must be included.

• Clearly write your RMA number on the top of the returned package. SIIG will

refuse to accept any shipping package, and will not be responsible for a product

returned without an RMA number posted on the outside of the shipping

carton.

• You are responsible for the cost of shipping to SIIG. Ship the product to the

following address:

SIIG, Inc.

6078 Stewart Avenue

Fremont, CA 94538-3152, USA

RMA #:

• SIIG will ship the repaired or replaced product via Ground in the U.S. and

International Economy outside of the U.S. at no cost to the customer.

PRODUCT NAME

DP FireWiire PCIe

FCC RULES: TESTED TO COMPLY WITH FCC PART 15, CLASS B

OPERATING ENVIRONMENT: FOR HOME OR OFFICE USE

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

THE PARTY RESPONSIBLE FOR PRODUCT COMPLIANCE

SIIG, Inc.

6078 Stewart Avenue

Fremont, CA 94538-3152, USA

Phone: 510-657-8688

About SIIG, Inc.

Founded in 1985, SIIG, Inc. is a leading manufacturer of IT connectivity

solutions (including Serial ATA and Ultra ATA Controllers, FireWire, USB,

and legacy I/O adapters) that bridge the connection between Desktop/

Notebooksystemsand external peripherals. SIIG continuesto grow by adding

A/V and Digital Signage connectivity solutions to our extensive portfolio.

SIIGproducts offer comprehensive usermanuals, many user-friendlyfeatures,

and are backed by an extensive manufacturer warranty. High quality control

standards are evident by the overall ease of installation and compatibility of

our products, as well as one of the lowest defective return rates in the industry.

SIIG products can be found in computer retail stores, mail order catalogs,

throughmajordistributors, system integrators, andVARsin the Americas and

the UK, and through e-commerce sites.

DPFireWire PCIeis a trademark of SIIG,Inc. SIIG andthe SIIG logo are registeredtrademarks

of SIIG, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. All

othernames usedin this publicationare for identificationonly andmay be trademarksof their

respective owners.

Indice

Altri manuali SIIG Hardware per computer

SIIG

SIIG USB 2.0 Bay Reader/Writer+Floppy Manuale utente

SIIG

SIIG JJ-EC2011-S1 Manuale utente

SIIG

SIIG JU-P40311-S1 Manuale utente

SIIG

SIIG NN-000032-S1 Manuale utente

SIIG

SIIG CyberParallel Dual Manuale utente

SIIG

SIIG SC-SAE312-S3 Manuale utente

SIIG

SIIG ID-P40411-S1 Manuale utente

SIIG

SIIG Serial ATA PCI Manuale utente

SIIG

SIIG CyberParallel ExpressCard Manuale utente

SIIG

SIIG JU-EP0012-S1 Manuale utente

SIIG

SIIG IO1037 Manuale utente

SIIG

SIIG JJ-PCM012-S2 Manuale utente

SIIG

SIIG SC-SAE612-S1 Manuale utente

SIIG

SIIG SoundWave 5.1 PCI-LP Manuale utente

SIIG

SIIG UltraATA 133 PCI Manuale utente

SIIG

SIIG CyberSerial POS 4000RJ Manuale utente

SIIG

SIIG Cyber I/O PCI Manuale utente

SIIG

SIIG Network Device EVTEK-5103 Guida all'installazione

SIIG

SIIG Silent Mini Notebook Cooler Manuale utente

SIIG

SIIG NN-EC2812-S1 Manuale utente

SIIG

SIIG eSATA II ExpressCard Manuale utente

SIIG

SIIG JU-PCM422-S2 Manuale utente

SIIG

SIIG CyberSerial ExpressCard Manuale utente

SIIG

SIIG ExpressCard 11-in-1 Reader/Writer Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente